Delta Dvp Series Ia-PLC Dvp04ad-S, Dvp14ss211t, Dvp08sm11n Electronics/Industrial Automation Programming Controller Module Delta PLC

Delta DVP series PLC.The analog input module DVP04AD-S/DVP04AD-S2 receives external 4-point analog signal input(voltage or current) and converts it into 14-bit digital signals. A DVP series slim type PLC can read data from DVP04AD-S/DVP04AD-S2 or write data to DVP04AD-S/DVP04AD-S2 by means of the instruction FROM/TO. There are 49 CRs (control registers) in the module, and each register has 16 bits.

Users can select input from voltage or current via wiring. Voltage input range is ±10VDC (resolution is 1.25mV). Current input range is ±20mA (resolution is 5μA).
Mounting Arrangements and Wiring Notes
DIN Rail Installation
The DVP-PLC can be secured to a cabinet by using the DIN rail that is 35mm high with a depth of 7.5mm. When mounting the PLC on the DIN rail, be sure to use the end bracket to stop any side-to-side motion of the PLC, thus to reduce the chance of the wires being pulled loose. On the bottom of the PLC is a small retaining clip. To secure the PLC to the DIN rail, place it onto the rail and gently push up on the clip. To remove it, pull down on the retaining clip and gently pull the PLC away from the DIN rail. Please see the figure on the right.
Wiring
1. Use 22-16AWG (1.5mm) single or multiple core wire on I/O wiring terminals. The specification of the
terminal is shown in the figure on the left hand side. The PLC terminal screws shall be tightened to
1.95kg-cm (1.7 in-lbs).
2. DO NOT place the I/O signal wires and power supply wire in the same wiring duct.
3. Use 60/75°C copper wires only